Installation Info about Water Softening Equipment

The conditions that need to be met for the installation of large-scale Water Softening Equipment are as follows:

1. The hardness of the source water is ≤8mmol/L (if the hardness of the source water is greater than 8mmol/L, it needs to be redesigned);

2. The equipment should be installed on a firm cement platform, and there should be drainage ditch nearby;

3. The salt tank should be placed close to the resin tank, and the length of the salt suction pipe should be shortened as much as possible;

4. Large-scale softened water equipment must be placed indoors, the ambient temperature cannot be lower than 2°C or higher than 50°C, and the humidity must be less than 95%, which is limited to 25°C;

5. The power supply shall be stable and meet the local power supply

6. When large-scale softened water equipment is directly connected to heating equipment, a pipe section of more than 3 meters should be maintained and a check valve should be installed;

7. To facilitate the replenishment of the regeneration agent, the regeneration agent is industrial salt without iodine

8. If underground well water or surface water is used as the water source for softening water, it is recommended that the user install a suitable fine filter device in front of the equipment to prevent the resin from being polluted by deep well sediment or other impurities, resulting in a long service life of the resin. decline.

Therefore must pay attention to whether these installation conditions are met when installing water softening equipment to avoid unnecessary problem.

More inquiries related to Water softening equipment please contact:

Mob& Wechat& WhatsApp: (+86)13544774483

Email: sales010@water-sy.com

We will provide high-quality, all-round comprehensive professional services for project consulting, system design, manufacturing, installation and commissioning, personnel training, etc